Making a different unique sound other than the window default for application whenever a program is launch or exit from your computer is a fantacy and groovy style that define your class when it comes to exploring your window computer.
But do your know that this bit of pleasure is a little technical, here is how it goes.
The sound format that is accepted here is the wav format, therefore any sound you want to use must be in wav format or try to convert using total converter or any other converter to wav format.
Click your control panel on your start menu
Double click sound and audio devices icon in control panel
At the window pop up, navigate to the sound tab and there you will see the sound scheme selected
Click the save as tab to save the sound with any name of yours
Highlight any of the window program from the program event, you will notice that the default sound is what was set by pressing the play sign to play it.
Click on browse tab to set your own sound which has already been in wav format by navigating to the destination folder, N.B; you will not see any sound if you have not convert it to wav format.
Select your unique sound and click the o.k tab.
Do that for all other program with your own personalized sound.
Click the apply and ok tab, there you are with your personalizes window sound.
Whenever my computer boot to window you will listen to the Dbanj song Ongbono feli for 30 seconds and You bad song by Wande coal when shutting window. Thanks form reading.
HOW TO CUSTOMIZE YOUR WINDOW COMPUTER WITH A UNIQUE SOUND OF YOURS
QUICK AND EASY WAY TO RECOVER YOUR FILES FROM A CRASHED HARD DISK DRIVE
Files in our daily work of life is very important as information worth billions of US dollars and more can be saved on a piece of word or spreadsheet package stored in a retrieval device like flash drive, hard disk or online system.
Accessing ones file(s) is the basic of saving or storing it onto a removable or fixed drive but the down time of these is when the device is crashed or damaged thereby denying one access to his files as the system disk won't boot due to the bad or damaged platters on the drive but never worry as i have outlined below a step by step procedures for you to recover back your files as long as the drive is still detectable by any computer system.
As a computer engineer and also writing from experience the basic ways for you to recover back your files here, is by pairing the drive to a working system which is the method i will discuss here.
Let's get started:
Firstly identified the crashed drive by removing it from the system after turning off and unplugging it from wall outlet source.
Get the necessary drive connector as for an I.D.E or S.A.T.A drive either a desktop or laptop hard drive.
Attach the connector to the crashed drive, in a case of desktop hard drive set the jumper connector to slave mode.
Connect the other end of the connector to a working system with updated anti-virus program.
Start and run the operating system of the working system and allow it to fully boot up and detect the drive.
Navigate to the crashed drive from the my computer interface, you can scan for virus first or skip the process if you have a good and updated anti-virus program installed.
Open and move to the destination folder you have your files, copy it to a folder on the working system drive.
Shut down the system and disconnect the drive device from the system.
You now have your files back in the working system.
Note: If a drive is crashed, it's not the end of drives as files can be copy from and unto the drive but it can't be used the primary storage device as it operating system program won't install on it.
In the case of a damaged or corrupted hard drive that cannot be access by the system but still detected, one is left with only the alternative of formatting the disk and making use of a recovery software to recover back the lost data files, even though that is more technical and time consuming.
